2009 Escape Engine Cylinder Diagram

Home, Auto Repair Library, Auto Parts, Accessories, Tools, Manuals & Books, Car BLOG, Links, Index

ford ignition firing order

Ford Firing Order

Copyright AA1Car

The firing order of an engine is the sequence the spark plugs fire. On engines with a distributor, the firing order is determined by the routing of the spark plug wires from the distributor cap to the spark plugs in each cylinder. When the piston is at top dead center (TDC) on the compression stroke, the rotor inside the distributor should be aligned with the number one (#1) spark plug terminal in the distributor cap. Ford V8 distributors rotate in a counter-clockwise direction, so the next plug wire in the cap would go to the next spark plug in the firing sequence for that engine. The distributor rotates clockwise on Ford V6 and straight 6-cylinder engines, and also clockwise on Ford 2.0L and 2.3L four-cylinder engines.

On most Ford engines the #1 cylinder is the first cylinder at the front of the engine on the passenger side (right side) of a rear-wheel drive car or truck. On front-wheel drive cars and minivans with a transverse (sideways) mounted V6, the #1 cylinder is the first cylinder on the rear side of the engine on the passenger (right) side.

The cylinders are numbered in sequence starting with the #1 cylinder going towards the back of the engine on each cylinder bank (see illustrations below). The only exception is the Nissan V6 in the Probe and Villager, which are numbered in a staggered sequence similar to a GM engine.

Ford V8 Firing Orders

The firing order for older Ford V8 engines (289, 302, 390, 427, 428, 460) is 1-5-4-2-6-3-7-8.

The firing order for older Ford 351, 5.0L EFI, 5,4L and 5.8L V8 engines is 1-3-7-2-6-5-4-8.

The firing order for 1990-2014 Ford modular 4.6L modular V8 engines is 1-3-7-2-6-5-4-8.

The firing order for 2011-2019 Ford "Coyot" 5.0L engines is 1-5-4-8-6-3-7-2.

The firing order for Ford Mustang GT350 5.2L "Voodoo" V8 with flatplane crankshaft is 1-5-4-8-3-7-2-6.

Ford Firing Orders.

Why The Firing Order Is Important

The correct firing order is very important because mixing up the spark plug wires may prevent the engine from starting, cause it to backfire and run very poorly if at all.

NOTE: On engines where two adjacent spark plugs fire right after each other, it is important to make sure the spark plug wires are not routed right next to each other for a long distance. This can cause crossfire between the plugs because the magnetic field created by the spark going to one plug may fire the next plug prematurely, causing the engine to run rough and misfire. To prevent this from happening, criss-cross the two plug adjacent plug wires to cancel out the magnetic induction.

On engines with distributorless ignition systems or coil-on-plug ignition systems, the firing order is controlled by the ignition module or engine computer. The computer receives an input signal from the crankshaft position sensor (and camshaft position sensor on some engines) to determine which piston is coming up to top dead center on its compression stroke. It then fires that spark plug, and the next and so on in the firing sequence.